SENCO’s 1 Gallon Finish & Trim air compressor is designed with the professional contractor in mind: compact, lightweight hand carry, sturdy, powerful, oil-free, 102 second pump up time, 27 second recovery time, low maintenance and warrantied. Our compressor really makes hard work easier. The PC1010N is lightweight at just 21 lbs. (9.53 kg), and its compact design measuring 14x13x10 ensures easy portability to any jobsite. The gauges on our keep watch over panel are easy to read and the integrated keep watch over panel is designed for simple access and straightforward operation. In addition, the PC1010N features an ultra-quiet 68 dBA noise level of operation – a standard garbage disposal is louder – and a rugged, rust-resistant, aluminum design. Each contractor and DIY enthusiast will agree this is a perfect “finish and D6 trim unit” for finish trim nailers, pin nailers and more – especially since its ¼” coupler is a universal design. That makes it compatible with a lot of air tools from the entire top manufacturers. The long life induction motor and oil free pump get rid of the need for oil and regular maintenance. Its direct drive pump/motor offer efficient operation. There are a large number of safety features included in the design of the PC1010N. As an example, the Motor/Pressure switch has a pressure release valve that automatically releases compressed air from the air compressor pump head and its discharge line when the air compressor reaches cut-out pressure or is shut off – allowing the motor to restart freely. Also, the motor has a protective breaker on the pump which trips if there is an over the top amperage draw – protecting both the operator and the motor itself. The air intake filter doesn’t wish to be replaced; it is reusable and will have to all the time be clean with its ventilation opening free from obstructions. It may be cleaned by the use of warm, soapy water and then rinsed and set out to air dry. Further, there’s a safety relief valve designed to prevent system failures by relieving pressure from the system when the compressed air reaches a predetermined level. Having been preset by the manufacturer, it will have to not be modified in any way. Additionally, the air tank drain valve is used to take away moisture from the air tank after the compressor is shut off. NEVER attempt to open the drain valve when more than 10 PSI of air pressure is in the tank! To open the drain valve, turn the knob counterclockwise then tilt the tank to make certain that all condensation drains through the valve. Additional features will also be seen in detail in the User Manual, included in the packaging. The power cord included with this unit is 6 feet long. If additional length/distance is needed, Senco recommends the use of one of our 50’ or 100’ Proflex or Push On ¼” Air Hoses – to be had on Amazon – as an alternative of an extension cord. If use of an extension cord is unavoidable, it will have to be plugged into a GFCI found in circuit boxes or secure receptacles. If use of an extension cord is unavoidable, refer to our operating manual and observe the really helpful cable length and wire gauge listed. Additionally, use only 3-blade extension cords that have 3-blade grounding-type plugs and 3-slot cord connectors that allows you to accept the plug from the PC1010N. Use only extension cords having an electrical rating not less than the rating of the product.
1-GALLON TANK & MAX PRESSURE OF 135 PSI – less than 2 minutes to pump up and no more than 30 seconds of recovery. Perfect for finish & trim work on the job and hobbies & crafts at home
OIL-FREE – requires virtually no maintenance and allows you to work in a cleaner air environment in comparison to legacy cast iron, belt driven, oil lubricated compressors
QUIET MOTOR – provides the entire power you wish to have for finish jobs, with significantly less noise than traditional gas compressors
COMPACT DESIGN – 14″x13″x10″ makes it easy to hand carry and load onto a truckbed or back seat for any number of finish jobs