The Fluke 113 True-RMS Utility Multimeter is a digital multimeter (often referred to as a multitester) that measures AC/DC voltage to 600V, resistance to 60 kiloohms, and capacitance to 9,999 microfarads. The meter has a diode check for checking out general-purpose germanium, silicon, and tool diodes, and a continuity beeper which supplies audible detection of resistance by turning on at not up to 25 ohms and off at 250 ohms. Additionally it is in a position to Concurrently check for voltage and continuity. This true RMS meter provides accurate readings when measuring linear or nonlinear a lot where the present or voltage has a sinusoidal or nonsinusoidal waveform and has both manual- and auto-ranging capabilities for user flexibility. A Max/Min serve as records signal fluctuations and a hold serve as freezes measurements at the display. The 6000-count resolution, 3-1/2 digit digital display is backlit for readability in low-light conditions. The meter is safety rated for Category III to 600V and Category IV to 300V. It uses a 9V battery (installed) with a battery life of roughly 300 hours without backlight and has a sleep mode to maximise battery life. The meter measures 6.58 x 3.35 x 1.81 inches (H x W x D) and weighs 13 oz./404 g. (H is height, the vertical distance from the lowest to perfect point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.) This meter features a holster with built-in probe holders for convenient storage.
Multimeters are electrical test meters that measure more than one properties of an electrical circuit, such as current, voltage, resistance, capacitance, and continuity. To be had in hand-held or benchtop models, multimeters diagnose electrical problems in electrical equipment, wiring, and tool supplies. Quite a lot of probes, clamps, and leads can be utilized to attach the meter to a circuit or device. Multimeters display information either in analog or digital form. Factors that influence meter choice come with the electrical properties to be measured, the expected range of results, and the required level of protection against transient voltage. Safety ratings are in line with International Electrotechnical Commission (IEC) standards for low-voltage test equipment. IEC 61010 delineates four overvoltage installation categories. Basically, a meter with a category IV rating will provide more protection against transient voltages than a meter with a lower category rating.
Fluke Corporation manufactures electrical checking out tools and software for industrial and commercial applications. The corporate, founded in 1948, is headquartered in Everett, WA.
What’s within the Box?
- Fluke 113 utility multimeter
- Test leads
- 9V battery
Digital multimeter measures AC/DC voltage, resistance, and capacitance and performs continuity and diode tests
True RMS meter provides accurate readings when measuring linear or nonlinear a lot where the present or voltage has a sinusoidal or nonsinusoidal waveform
Concurrently checks for voltage and continuity
Manual- and auto-ranging modes for user flexibility
Safety rated for Category III to 600V and Category IV to 300V